Permatex 5 Minute Gel Epoxy .84 fl. oz. dual syringe, carded
Permatex’s General Purpose 5 Minute Gel Epoxy provides the flexibility to reposition before the setting time. The fast setting, two-part adhesive and filler system is specially formulated with a Blue Dye Indicator that disappears when it’s fully mixed and ready to use. The advanced gel formulation reduces mess and waste compared to traditional epoxies; unique indicator system takes the guesswork out of “ready to use”.
- Non-drip formula allows for mess free application
- Can easily be applied to overhead and hard to reach places
- Sets in just 5 minutes / Cures in 10
- Blue dye indicator disappears when epoxy is ready to apply
- No clamping required
- Bonds to metals, hard plastics, ceramics and more!
Permatex General Purpose Epoxies are two part, high
strength, clear, epoxy adhesives that are available in several
working times. Permatex General Purpose Epoxies are ideal
for complex, multi-piece assemblies. They are water and
solvent resistant and available in dual syringes or tubes.
• Will not shrink
• Various curing cycles
• No clamping needed
• Fills gaps
• Nearly colorless
• Impact resistant
• Water resistant
To bond rigid materials including:
• Plastics (Excluding polyethylene and polypropylene)
DIRECTIONS FOR USE
1. Protect work area from accidental spills.
2. Surface must be clean, dry and free of grease & oil.
3. Roughen surfaces with sandpaper or other abrasives.
4. Use a sharp blade to cut off the tips of both nozzles.
5. Depress plunger on syringe or squeeze out of tubes
equal amounts of resin and hardener from tubes.
Thoroughly mix resin and hardener on a clean
discardable surface for at least one (1) minute (20 to 25
seconds in the case of the one minute epoxy) or until
uniform in color.
6. Apply to surfaces being repaired. Assemble parts
immediately. Remove excess epoxy immediately.
7. Allow bond to set for the fixture time before moving
DIRECTIONS FOR STATIC MIXER
1. Clean, dry and roughen surfaces to be bonded.
2. Remove black storage cap from the middle of black
plunger. Turn syringe nozzle end up and pull back on black plunger about 1/8”. Allow bubbles to rise to the top.
3. Snap off and discard end of syringe.
4. Insert static mixer into nozzle and twist 90 degrees.
NOTE: Static mixer applicator must lock in place before
5. Push plunger evenly to dispense epoxy. Dispense
directly onto surface to be bonded.
NOTE: Epoxy sets in 5 minutes and may be handled in
15 minutes. Cooler temperatures may require longer set
6. When finished, remove static mixing nozzle and discard.
Wipe any excess epoxy from tip and replace black
NOTE: Permatex General Purpose Epoxy Products will
not bond polyethylene and polypropylene plastics.
1. For any cleanup, use isopropyl alcohol before the
material is allowed to dry/cure.
2. Clean hands with Permatex Fast Orange® hand cleaner
or soap and water.
There are no reviews yet.