AMBERSIL DRY MOLY – 400 ml MADE IN UK

Description

DRY MOLYBDENUM DISULPHIDE LUBRICANT

AMBERSIL DRY MOLY is a resin bonded, high pressure resistant, dry film lubricant containing Molybdenum Disulphide for metal-to-metal lubrication where a wet film cannot be tolerated. Once applied, the MoS2lubricant prevents seizing, fretting, scuffing and reduces friction. The thin film also helps prevent corrosion and repels water.

APPLICATIONS

Use for the assembly and running in of components to reduce fretting and scuffing where a wet film cannot be used. Apply to threaded and close tolerance components to prevent seizing and aide assembly and disassembly. Particularly effective where high load bearing surface to surface contact is present.

•Mounting of longitudinal press fits (e.g. bolts and bearing seats)

•Assembly of screws and seals

•Surface treatment of rolling and sliding bearings to improve running-in

•Lubrication of guides and joints

•Bearing lubrication for wheel bearings and kiln carts

•Lubrication of open gears

•For use where a wet-film lubricant is undesirable

DIRECTIONS FOR USE

•Shake can well (1-2 minutes) until agitator ball is free.

•Ensure application surface is clean, dry, and free from grease, oil and contaminants.

•Hold can upright and spray a thin, even coating from about 25cm away.

•Resin will be touch-dry after 2 – 3 minutes, and ready for use after approximately 2 hours.

•Lightly polish the cured film with a soft, lint-free cloth to improve performance.

STORAGE

The product may be stored at normal ambient temperatures and has a shelf life of not less than 72 months with correct storage. Aerosols should always stored below 50OC, away from direct heat and naked flame.

HEALTH AND SAFETY

Health and Safety sheet available separately.