Shipping to All Over Saudi Arabia
Gasketing of flanges, gearboxes and other motor housings
LOCTITE 222 Low Strength Purple Threadlocker is ideal for fastener diameters of 1/4″ (6mm) and smaller. Its controlled lubricity allows for accurate clamp loads. Parts can be separated using hand tools.
LOCTITE 406 is a fast curing, wicking grade viscosity, surface insensitive instant adhesive for post applications. This clear, surface insensitive, one part, room temperature cure wicking grade instant adhesive is designed for OEM assembly of plasics and elastomeric materials where very fast fixturing is required. Commercial Item Description A-A-3097: Type II Class 1
Pattex Power Epoxy Universal Mix in a tube gives you a super strong bonding power you need for most materials. Not only does it dry transparently but it won’t expand or shrink when curing. Resistant to water, oil and common solvents, Pattex Power Epoxy Universal Mix in a tube can be used for outdoors and indoors, you can also paint, sand, polish and even drill it!
WEICON Gasket Maker is a strong and permanently elastic special sealant that cures with air humidity and practically without shrinkage. The Gasket Maker has a very good adhesion on steel, aluminium, glass, ceramic, and many other materials. It has an excellent temperature, oil and grease resistance, is pressure- and aging-resistant, UV-stable and permanently elastic. The special sealant can be used on engines and water pumps, gears and axles, oil sumps and in many other applications.
LOCTITE 577 is designed for the locking and sealing of metal pipes and fittings as well as other threaded assemblies. The product provides an instant, low-pressure seal for metal pipes and fittings. It will not creep, shrink or shred. It has excellent chemical and thermal resistance and offers less migration of liquid product after application. NEW: Henkel has recently improved the product formulation of LOCTITE 577 providing:
Ensure surfaces to be bonded are clean and free of dust, grease or oil. Surfaces should not be visibly wet or continuously damp.
Substrates must be stable. Remove the dirt with the appropriate solvent or sand down surfaces and clean afterwards from the dust. Before application, mask off the adjacent area with foil or tape, if necessary