Permatex Electrical Contact & Parts Cleaner
Suited for cleaning electrical and electronic devices, this fast evaporating, noncorrosive cleaner leaves no residue. It removes grease, dirt, oil, flux and other surface contaminants. Designed to be an alternative to CFC-113, 1,1,1-trichloroethane and perchloroethylene solvents.
Suggested Applications: Electronic parts: circuit boards, computer components, relay switches. Electric parts: electric motors, generators, starters, pumps, motor windings, solenoids, and compressors.
Suggested Applications: Electronic parts: circuit
boards, computer components, relay switches, etc.
Electric parts: electric motors, generators, starters,
pumps, motor windings, solenoids, compressors, etc.
- PRODUCT DESCRIPTION
Permatex Electrical Contact and Parts Cleaner is a fast
evaporating cleaner that leaves no residue. The product is
suited for cleaning electrical and electronic devices. It is
designed to be an alternative to CFC-113, 1,1,1-trichloroethane
and perchloroethylene solvents. VOC compliant in all 50 states.
Permatex Electrical Contact & Parts Cleaner is used as an
electrical contact and parts cleaner to remove grease, dirt, oil,
flux and other surface contaminants from sensitive
electrical/electronic devices. Permatex Electrical Contact &
Parts Cleaner can also be used to clean motorized instruments,
control panels, electrically driven parts, motors, and other
electronic devices requiring a fast acting, low residue
DIRECTIONS FOR USE (Read all directions before using
1. DO NOT apply to energized equipment or where there
is a residual electrical potential from a component
such as a capacitor.
2. Hold can 6 to 8 inches from surface to be cleaned.
3. Spray surface to be cleaned using 15 second bursts.
4. The extension tube may be used for pinpoint application
or hard-to-reach areas.
5. For stubborn residues, repeat application.
6. For difficult applications, swabs or lint free cloths may be
7. Allow to dry completely before re-energizing system.
SPECIAL USAGE WARNINGS: Contents EXTREMELY
FLAMMABLE. DO NOT smoke while using this product.
Extinguish all flames, pilot lights and heaters. DO NOT
apply while equipment is energized. Vapors will
accumulate quickly and may ignite. Use only with
adequate ventilation; maintain ventilation during use and
until vapors are gone. ELECTRICAL SHOCK HAZARD:
The aerosol can will conduct electricity. Keep away from
all live electrical sources including battery terminals,
solenoids, electrical panels, electronic components or
where there is a residual electrical potential from a a
component such as a capacitor. DO NOTuse while the
ignition is in the “on” position. Failure to observe these
warnings may result in serious injury from flash fire and/or
- For Cleanup
1. Clean hands with Permatex brand hand cleaners.
Permatex Electrical Contact & Parts Cleaner is compatible
with most metals, many plastics and elastomers. The following
table shows the effects of the product sprayed onto plastic and
elastomer samples for a burst of 15 seconds to duplicate actual
in-use applications. The samples were then allowed to dry for
30 minutes and their appearance was observed. Since plastics
and elastomers can be formulated and manufactured to have a
wide range of physical properties, it is recommended that
compatibility for a particular grade or product formulation be
established prior to cleaning. The following table shows the
effects of the product on various plastics and elastomers.
|Permatex Electrical Contact & Parts Cleaner Tds|