Description

• PRODUCT DESCRIPTION
  Permatex Electrical Contact and Parts Cleaner is a fast
  evaporating cleaner that leaves no residue. The product is
  suited for cleaning electrical and electronic devices. It is
  designed to be an alternative to CFC-113, 1,1,1-trichloroethane
  and perchloroethylene solvents. VOC compliant in all 50 states.
  TYPICAL APPLICATIONS
  Permatex Electrical Contact & Parts Cleaner is used as an
  electrical contact and parts cleaner to remove grease, dirt, oil,
  flux and other surface contaminants from sensitive
  electrical/electronic devices. Permatex Electrical Contact &
  Parts Cleaner can also be used to clean motorized instruments,
  control panels, electrically driven parts, motors, and other
  electronic devices requiring a fast acting, low residue
  degreasing agents.
  Switches
  Contacts
  Relays
  PC boards
  Motors
  Sensors
  DIRECTIONS FOR USE (Read all directions before using
  this product)
  1. DO NOT apply to energized equipment or where there
  is a residual electrical potential from a component
  such as a capacitor.
  2. Hold can 6 to 8 inches from surface to be cleaned.
  3. Spray surface to be cleaned using 15 second bursts.
  4. The extension tube may be used for pinpoint application
  or hard-to-reach areas.
  5. For stubborn residues, repeat application.
  6. For difficult applications, swabs or lint free cloths may be
  used.
  7. Allow to dry completely before re-energizing system.
  SPECIAL USAGE WARNINGS: Contents EXTREMELY
  FLAMMABLE. DO NOT smoke while using this product.
  Extinguish all flames, pilot lights and heaters. DO NOT
  apply while equipment is energized. Vapors will
  accumulate quickly and may ignite. Use only with
  adequate ventilation; maintain ventilation during use and
  until vapors are gone. ELECTRICAL SHOCK HAZARD:
  The aerosol can will conduct electricity. Keep away from
  all live electrical sources including battery terminals,
  solenoids, electrical panels, electronic components or
  where there is a residual electrical potential from a a
  component such as a capacitor. DO NOTuse while the
  ignition is in the “on” position. Failure to observe these
  warnings may result in serious injury from flash fire and/or
  electrical shock.
• For Cleanup
  1. Clean hands with Permatex brand hand cleaners.
  COMPATIBILITY
  Permatex Electrical Contact & Parts Cleaner is compatible
  with most metals, many plastics and elastomers. The following
  table shows the effects of the product sprayed onto plastic and
  elastomer samples for a burst of 15 seconds to duplicate actual
  in-use applications. The samples were then allowed to dry for
  30 minutes and their appearance was observed. Since plastics
  and elastomers can be formulated and manufactured to have a
  wide range of physical properties, it is recommended that
  compatibility for a particular grade or product formulation be
  established prior to cleaning. The following table shows the
  effects of the product on various plastics and elastomers.