Description

PRODUCT DESCRIPTION 
Permatex Black Super Weatherstrip Adhesive is a black
viscous liquid contact type cement for all types of
weatherstripping. Black Super Weatherstrip Adhesive is an
air-drying contact cement that allows quick bonding yet
maintains enough versatility in tack to allow large areas to be
spread and bonded at one time. The drying characteristics
allow for repositioning parts after contact is made. The
maximum strength of Black Super Weatherstrip Adhesive is
attained after all the solvent has been released. Non-porous
surfaces, if assembled while the adhesive is wet, will prevent
the release of solvent, consequently, the adhesive will take
longer to dry and develop maximum strength.
PRODUCT BENEFITS
• Water resistant
• Excellent chemical resistance
• Fast drying
• Withstands temperature extremes
TYPICAL APPLICATIONS
• Door and trunk moldings
• All types of automotive weatherstripping
• Body side moldings
• Decorative trim
DIRECTIONS FOR USE
For assembly as form-in-place gasket
1. Clean surfaces thoroughly. Use abrasives to remove
any powdery mold release from the new
weatherstripping.
2. Apply a thin, even film to both surfaces.
3. Allow to dry until the surfaces are tacky (about 3-4
minutes).
4. Bond the two surfaces together, and apply enough
pressure to produce uniform contact.
Note: The early strength of Black Super Weatherstrip

Adhesive is enough to hold most parts together.
However, maximum strength is obtained after the
adhesive is completely dry. Aging of the bond and
exposure to moderate heat increases strength.
For Cleanup
1. Use lacquer thinner or any hydrocarbon solvent