Email: info@industrial-mall.com

Shipping To All Over Saudi Arabia

iconHotline: 

Email: info@industrial-mall.com

Shipping To All Over Saudi Arabia

iconHotline: 

Email: info@industrial-mall.com

Shipping To All Over Saudi Arabia

iconHotline: 

Product Details

Permatex High Temperature Sleeve Retainer

Permatex High Temperature Sleeve Retainer

OEM specified. High temperature, up to 400ºF (204ºC), anaerobic adhesive that secures slip and press fit assemblies. Adds up to 3,000 PSI holding power. Restores fit to worn or out-of-tolerance assemblies. Prevents surface corrosion. Conforms to ASTM D5363 AN0411 (Mil-R-46082, Type II).

Automobile

Suggested Applications: Cylinder sleeves, valve guides, valve seats, bearings and bushings, woodruff keys, and liner assemblies

Motorcycle

Suggested Applications: Valve guides

Heavy Duty

Suggested Applications: Retaining bushings, cup plugs, gears, dowel pins, oil seals, ring gear bolts, differential lock pinswheel bearins, idler shafts, press fit bearings

Compare

Share this product

Description

PRODUCT DESCRIPTION
Permatex High Temperature Sleeve Retainer is a one
component, solvent-free, fast curing, anaerobic
adhesive/sealant. It is a green colored liquid resin that
hardens and cures in the absence of air. Permatex High
Temperature Sleeve Retainer self-hardens into a tough plastic
material when it is confined between close-fitting metal parts.
The cured adhesive is a thermoset plastic suitable for
exposure to most solvents and engine fluids. OEM Specified.
Meets or exceed the requirements of Military Specification MilR-46082B, Type II.
PRODUCT BENEFITS
No mixing
No curing outside of joint
No on-torque adjustments needed
Restores fit to worn assemblies
Prevents fretting and corrosion
Allows the use of slip fit or press fit
For use on assemblies with gaps up to 0.007” diametral
TYPICAL APPLICATIONS
Cylinder sleeves
Valve seats
Bearings and bushings
Woodruff keys
Liner assemblies
Valve guides
DIRECTIONS FOR USE
1. Remove any grease or oil by using Permatex Brake &
Parts Cleaner.
2. For slip fitted assemblies, apply adhesive around the
leading edge of the collar and use a rotating motion
during assembly.
3. For press fits, adhesive should be applied thoroughly to
both bond surfaces and assembled at high press-on
rates.
4. For shrink fitted assemblies, the adhesive should be
coated onto the pin; the collar should then be heated to
create sufficient clearance for free assembly.
5. For faster cure rates, use Permatex  Surface Prep on
both surfaces.
6. Parts should not be disturbed until sufficient handling
strength is achieved.
7. Any material that is on the outside of the assembly will
not cure. Wipe off with a dry cloth.

For Cleanup
1. Residual liquid films outside the joints are readily soluble
in Permatex  Brake & Parts Cleaner.
2. Cured product can be removed with a combination of
soaking in Permatex Gasket Remover and mechanical
abrasion such as a wire brush.

For Disassembly
1. Apply localized heat to assembly to approximately 232C
(450F). Disassemble while hot.
For Reassembly
1. Remove any loose product from the assembly.
2. Apply primer to mating parts.
3. Assemble as per directions.

TECHNICAL DOCUMENTS
Permatex High Temperature Sleeve Retainer Tds

Reviews

There are no reviews yet.

Be the first to review “Permatex High Temperature Sleeve Retainer”

Your email address will not be published. Required fields are marked *