Email: info@industrial-mall.com

Shipping To All Over Saudi Arabia

iconHotline: 

Email: info@industrial-mall.com

Shipping To All Over Saudi Arabia

iconHotline: 

Email: info@industrial-mall.com

Shipping To All Over Saudi Arabia

iconHotline: 

Product Details

Permatex Electrical Contact & Parts Cleaner

Suited for cleaning electrical and electronic devices, this fast evaporating, noncorrosive cleaner leaves no residue. It removes grease, dirt, oil, flux and other surface contaminants. Designed to be an alternative to CFC-113, 1,1,1-trichloroethane and perchloroethylene solvents.

Automobile

Suggested Applications: Electronic parts: circuit boards, computer components, relay switches. Electric parts: electric motors, generators, starters, pumps, motor windings, solenoids, and compressors.

Marine

Suggested Applications: Electronic parts: circuit
boards, computer components, relay switches, etc.
Electric parts: electric motors, generators, starters,
pumps, motor windings, solenoids, compressors, etc.

Compare

Share this product

Description

  • PRODUCT DESCRIPTION
    Permatex Electrical Contact and Parts Cleaner is a fast
    evaporating cleaner that leaves no residue. The product is
    suited for cleaning electrical and electronic devices. It is
    designed to be an alternative to CFC-113, 1,1,1-trichloroethane
    and perchloroethylene solvents. VOC compliant in all 50 states.
    TYPICAL APPLICATIONS
    Permatex Electrical Contact & Parts Cleaner is used as an
    electrical contact and parts cleaner to remove grease, dirt, oil,
    flux and other surface contaminants from sensitive
    electrical/electronic devices. Permatex Electrical Contact &
    Parts Cleaner can also be used to clean motorized instruments,
    control panels, electrically driven parts, motors, and other
    electronic devices requiring a fast acting, low residue
    degreasing agents.
    Switches
    Contacts
    Relays
    PC boards
    Motors
    Sensors
    DIRECTIONS FOR USE (Read all directions before using
    this product)
    1. DO NOT apply to energized equipment or where there
    is a residual electrical potential from a component
    such as a capacitor.
    2. Hold can 6 to 8 inches from surface to be cleaned.
    3. Spray surface to be cleaned using 15 second bursts.
    4. The extension tube may be used for pinpoint application
    or hard-to-reach areas.
    5. For stubborn residues, repeat application.
    6. For difficult applications, swabs or lint free cloths may be
    used.
    7. Allow to dry completely before re-energizing system.
    SPECIAL USAGE WARNINGS: Contents EXTREMELY
    FLAMMABLE. DO NOT smoke while using this product.
    Extinguish all flames, pilot lights and heaters. DO NOT
    apply while equipment is energized. Vapors will
    accumulate quickly and may ignite. Use only with
    adequate ventilation; maintain ventilation during use and
    until vapors are gone. ELECTRICAL SHOCK HAZARD:
    The aerosol can will conduct electricity. Keep away from
    all live electrical sources including battery terminals,
    solenoids, electrical panels, electronic components or
    where there is a residual electrical potential from a a
    component such as a capacitor. DO NOTuse while the
    ignition is in the “on” position. Failure to observe these
    warnings may result in serious injury from flash fire and/or
    electrical shock.
  • For Cleanup
    1. Clean hands with Permatex brand hand cleaners.
    COMPATIBILITY
    Permatex Electrical Contact & Parts Cleaner is compatible
    with most metals, many plastics and elastomers. The following
    table shows the effects of the product sprayed onto plastic and
    elastomer samples for a burst of 15 seconds to duplicate actual
    in-use applications. The samples were then allowed to dry for
    30 minutes and their appearance was observed. Since plastics
    and elastomers can be formulated and manufactured to have a
    wide range of physical properties, it is recommended that
    compatibility for a particular grade or product formulation be
    established prior to cleaning. The following table shows the
    effects of the product on various plastics and elastomers.
TECHNICAL DOCUMENTS
Permatex Electrical Contact & Parts Cleaner Tds

Reviews

There are no reviews yet.

Be the first to review “Permatex Electrical Contact & Parts Cleaner”

Your email address will not be published. Required fields are marked *